| |
LW6EAH > PTCII 13.05.04 17:32l 46 Lines 1380 Bytes #999 (0) @ WW
BID : 000162LW6EAH
Read: GUEST DG6LAY DL3TN DL5SP
Subj: Re:LINFBB + PTCIIPro config ???
Path: DB0FHN<DB0RGB<OK0PPL<DB0RES<ON0AR<7M3TJZ<JE7YGF<LU6DTS<LU7EC<LU7DR<
LW4DEM<LU6DG
Sent: 040511/2013Z @:LU6DG.8109.BA.ARG.SA #:2305 [Punta Alta] $:000162LW6EAH
From: LW6EAH@LU6DG.8109.BA.ARG.SA
To : PTCII@WW
> I am battling to get LINFBB and a PTCIIPro TNC to work .. I am able to
> get
> Pactor to work on WINFBB and actually have a PTCIIPro running on my
> WinFBB
> BBS ..
> My PORT.SYS file has the "H" for PTC working ... LinFBB apparently uses
> the "H" for WA8DED Hostmode ...
> My existing AX25.CONFIG file doesn't have any mention of PTCII in it
> because I don't know what drivers I should use .. The PTCII is
> apparently
Is this tnc capable to work in kiss mode? You should switch it to kiss
mode, then add a line to axports, load ax25 and mkiss modules in they are
not built in, and then add the interface with kissattach.
Whith all this done you are ready to load linfbb and it will be able to
use this tnc (if configured to do so).
Any question, just ask.
> The PTCII is apparently using WA8DED Hostmode .. How does one configure
> this in Linux AX25 ???
As far as I know, you can't.
> I also have two packet TNC daughter boards installed in the PTCIIPro
> making the unit a three-port device .. How does one configure these two
> packet TNC's in Linux/LinFBB ??? If the PTCII was running in KISS mode,
> I could use the MKISS and KISSATTACH commands to set up the three ax25
> ports required ..
I think so.
-------------
Rodolfo Brasnarof LW6EAH
LW6EAH@LU6DG.8109.BA.ARG.SA
lw6eah@qsl.net
Punta Alta
Argentina
Read previous mail | Read next mail
| |
