| |
CX2SA > SATDIG 04.07.05 08:30l 170 Lines 5524 Bytes #999 (0) @ WW
BID : 6170_CX2SA
Read: GUEST
Subj: AMSAT-BB-digest V2004 #777 5/7
Path: DB0FHN<DB0FOR<DB0SIF<DB0FHK<DB0FBB<DB0IUZ<DB0GOS<DB0RES<DK0WUE<7M3TJZ<
HS1LMV<CX2SA
Sent: 050704/0717Z @:CX2SA.LAV.URY.SA #:6170 [Minas] FBB7.00e $:6170_CX2SA
From: CX2SA@CX2SA.LAV.URY.SA
To : SATDIG@WW
Message: 15
Date: Mon, 4 Jul 2005 00:51:55 +0200
From: "IW7ECJ, Joe" <iw7ecj@libero.it>
Subject: R: [amsat-bb] FT-847 Computer Control
Hi Simon...
> I am coming to the opinion that the only radio(s) I can correctly use are
> from ICOM as the transmit frequency of the TS-2000 cannot be changed by
> computer control while in transmit mode. I think either the IC-7000 or
> IC-910H will be used.
>
> Simon Brown
HRD updates My TS-2000's TX frequency even with the PTT pressed...
You say this is not possible... Are you referring to older firmwares, maybe?
73 de Joe, IW7ECJ
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
------------------------------
Message: 16
Date: Mon, 4 Jul 2005 00:44:43 +0200
From: "IW7ECJ, Joe" <iw7ecj@libero.it>
Subject: R: Helixes and VO-52 (Was: [amsat-bb] Polarization of HAMSAT
downlink)
Hi Dom, Jim and ED...
Your comments are truly appreciated...
As I said, I was going to try and start my Sat adventure with a couple of
QFHs but, after having read your wise suggestion, I believe I'll put the
project on ice for a while...
I want to investigate on 2M/70Cm yagis and try and build a couple of them
for my future Sat station...
Very kind of you to help me understand a bit more each time I read your
messages...
Thanks A LOT!
73 de Joe, IW7ECJ
> Da: i8cvs [mailto:domenico.i8cvs@tin.it]
> Oggetto: Re: Helixes and VO-52 (Was: [amsat-bb] Polarization of HAMSAT
> downlink)
>
> Hi Joe, IW7ECJ
>
> to start with moderate investment and good efficiency a linear
> horizontal polarization is advisable for uplink and downlink because
> in any circumstance if RHCP or LHCP is required in that particular
> moment you lose only 3 dB with a little more QSB and this is acceptable
> considering that manually switching RHCP/LHCP for the uplink and
> downlink during a pass searching for the best signal it also make the life
> hard to the LEO operator and probably to lose 3 dB is better.
>
> In addition linear horizontal polarization allow you to use the same
> antennas at maximum efficiency with tropo traffic due of polarization
> match with the others and this is what many VHF/UHF stations do
> using high gain linear antennas for satellite but only for contacts during
> orbits with low satellite elevation.
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
------------------------------
Message: 17
Date: Sun, 3 Jul 2005 18:35:43 -0400
From: "Lawn, Richard" <RLawn@uarts.edu>
Subject: [amsat-bb] 5400 and Nova
I've been having trouble again with my EL rotor (G-5400B) after rebuilding it
and replacing the pot. When I attempt to calibrate things under Nova using the
SASI interface the Raw value jumps all over the place. It was briefly stable
and then went nuts again. I hate the thoughts of tearing it down again or
sending it off to Yaesu this time for repair but may not have any choice. Any
advice?
Rick
W2JAZ
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
------------------------------
Message: 18
Date: Sun, 3 Jul 2005 21:03:16 EDT
From: VEFRH@aol.com
Subject: Re: [amsat-bb] FT-847 Computer Control
In a message dated 7/3/2005 1:54:37 P.M. Eastern Standard Time,
simon@hb9drv.ch writes:
Sadly I don't think any Yaesu HF radios (except maybe the FTDX-9000) can be
updated while you are in TX mode. So VOX or making shorts breaks may well be
the only alternative.
Simon Brown
- ---
www.hb9drv.ch www.laax.ch
I am using a Uni_sat doppler and rotator controller.
It works very well to control both uplink and down link frequencies
My Radios are a FT-847 and a FT- 736 They can run either on their own or
together.
search for Uni_Trac on the web to see this device.
73
Robin Haighton VE3FRH/GD4INU
Past President AMSAT-NA
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
------------------------------
Message: 19
Date: Mon, 04 Jul 2005 02:08:22 +0000
From: "Angelo Glorioso" <n5uxt@hotmail.com>
Subject: [amsat-bb] AO-51 UP AND RUNNING AGAIN
Thanks to the hard work of the Echo Command Team, AO-51 is up and running
again tonite.
Great Job Guy!!!!
73 de Angelo
- ---------------------------------------------------------
If you don't ask, you will never know!!
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
------------------------------
Message: 20
Date: Sun, 03 Jul 2005 22:18:42 -0400
From: John Meeks <jmeek@gaslightmedia.com>
Subject: [amsat-bb] AO-51 ECHO
Heads up to the left coast: ECHO is back.
kc8zfn
en75
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
Read previous mail | Read next mail
| |