| |
G8MNY > TECH 14.09.04 21:07l 31 Lines 1304 Bytes #999 (0) @ WW
BID : 10769_GB7CIP
Read: GUEST OE7FMI
Subj: Pawsey Stub Coax Balun
Path: DB0FHN<DB0RGB<OK0PPL<DB0RES<ON0AR<7M3TJZ<ZL2TZE<GB7YFS<GB7CIP
Sent: 040914/1750Z @:GB7CIP.#32.GBR.EU #:10769 [Caterham] $:10769_GB7CIP
From: G8MNY@GB7CIP.#32.GBR.EU
To : TECH@WW
By G8MNY (new Graphics Dec 03)
This type of balun is to be found in most textbooks & many aerial designs. It
is a 1:1 balun & does not alter the impedace.
Balun is ¬ wave of scrap coax alongside the feeder (a pipe will do).
ÚÄÄÄÄÄÄÄÄÄÄÄÄ¿
BÄÂÄ@ dead coax ³ @=Solder
³ ÚÍÍÍÍÍÍÍÍÍÍÍÍÏ@ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
ÀÄ) FEEDER
BÄÄÄÁÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
The feeder inner is connected to the dead coax braid BB are the 50ê balanced
feed points. The dead coax is what it says, a shorted out at both ends bit that
could even be copper pipe of the same diameter. It is connected to the feeder
¬ wave back from the aerial where the braids join together. At the aerial end
the dead coax is connected to the feeder's inner.
This works by making the aerial connections look "balanced", as the ñ voltage
phases appear to radiate equally from both halves of the balanced ¬ wave lines
& hence cancel, the 2 balanced folded ¬ waves look like a « wave where the
centre is at RF ground & therefore can be connected to the feed coax outer
without any RF left on the outer of the coax skin.
Why don't U send an interesting bul?
/QSL
73 De John, G8MNY @ GB7CIP
Read previous mail | Read next mail
| |
