| |
ZL3AI > APRS 01.10.00 10:46l 249 Lines 6895 Bytes #999 (0) @ WW
BID : 33709_ZL3AI
Read: GUEST
Subj: TAPR Digest, Sep 28, 4/4
Path: DB0MRW<OK0PKL<OK0PPR<OK0PPL<OK0POK<9A0YRB<HA5OB<HA3PG<VE1DRG<7M3TJZ<
KF9UG<N8ZFM<ZL2TZE<ZL2TZE<ZL2WA<ZL2BAU<ZL3VML
Sent: 000929/1059Z @:ZL3VML.#80.NZL.OC #:41790 [Chch-NZ] FBB7.00g25 $:33709_ZL3
From: ZL3AI@ZL3VML.#80.NZL.OC
To : APRS@WW
Subject: RE: Low Cost Radios
From: "Brian B. Riley" <brianbr@macconnect.com>
Date: Thu, 28 Sep 2000 16:39:52 -0400
X-Message-Number: 18
> -----Original Message-----
> From: Mark Fellhauer
> Sent: Thursday, September 28, 2000 3:39 AM
[snip]
> Not too long ago I touted the excellent value the 200 series
> Kenwood radios are for APRS/PACKET.
N1BQ-3 (earlier as KA2BQE-3) APRS digi is a TM-231 that has been in
24/7 digital service since 1991 as either a node or a digi. Only things
wrong are its memory battery is gone and the display backlight is gone.
The battery is no problem as it is connected to a 1200 AH battery bank
.... power 'dips' simply don't happen here.
----------------------------------------------------------------------
Subject: HamHuds and UHF and MCX-100's oh my!
From: David VanHorn <dvanhorn@cedar.net>
Date: Thu, 28 Sep 2000 15:40:12 -0500
X-Message-Number: 19
Looking over my ebay MCX-100 that arrived today..
The frequency control prom could easily be "faked" by a resident
microcontroller.
It would take, at worst, one wire into the synth box, and it could even be
done with an optical fiber (for the purists :)
That would give you a frequency-agile 440 rig capable of 9600.
As I proposed before, a packet (which I call an "ad") could be broadcast
periodically on 2 meters, telling the location, frequency, and PHG of the
local 440 nets.
A smart device like the HamHud could interpret these ADs, and tell the
radio where to tune, based on where (physically) you are relative to the
available 440 nets. Figuring out where the closest 440 net is wouldn't be
any harder than figuring the range to any other APRS station.
I need to get a little more info on how the radio uses the prom, but I
already know how to construct the right word to put the radio on any given
frequency.
This would end up being a little board that plugs into the PROM socket, and
you'd have to drill a small hole to route the optical fiber out of the
shields. The whole circuit might be as little as four active components.
The key concept here is that this scheme eliminates any need for a
nationwide 440 freq, and should allow a lot more traffic in a given area,
since you can have multiple nets overlapping.
--
Where's dave? http://www.findu.com/cgi-bin/find.cgi?kc6ete-9
----------------------------------------------------------------------
Subject: RE: Just a thought....
From: "Brian B. Riley" <brianbr@macconnect.com>
Date: Thu, 28 Sep 2000 16:49:59 -0400
X-Message-Number: 20
> -----Original Message-----
> From: Alex
> Sent: Thursday, September 28, 2000 12:57 PM
[snip]
> When I writing that silly reply about the off switch, I was
> wondering if it was possible and acceptable to write some sort
> of generic algorithm that could be used by any APRS software
> package to validate paths entered by the user. This algorithm
> could have rules to prevent the user from setting its path to
> say WIDE,WIDE,WIDE or WIDE,GATE,WIDE,TRACE7-7....
I belive PocketAPRS has been doing that since early Beta days ...
----------------------------------------------------------------------
Subject: SUNSAT APRS Schedule
From: Bob Bruninga <bruninga@nadn.navy.mil>
Date: Thu, 28 Sep 2000 19:57:04 -0400 (EDT)
X-Message-Number: 21
APRS users
SUNSAT is entering a new phase for APRS on 4 October for a week. The
downlink will be about 8 dB stronger and on 2 meters with little doppler.
Tune to 145.825 9600 baud with your D700 or D7(G) and see who you see.
You should be able to receive on any mobile Antenna and even a good
rubberduck. Until 4 Oct, SUNSAT is still in APRS mode J. I saw KB0VBZ
and N2OGB-7 on UO22 toinight, so glad to see some activity.
de WB4APR, Bob
Here is their announcement:
--------------------------------------------------------------------
Sunsat (SO-35) will be in its Parrot Repeater Mode for voice passes
during the UN World Space Week from 4 to 10 October 2000. In this
mode Sunsat continuously cycles through a 10 second recording (single
tone to indicate the start) and playback (double tone) period. The
up and downlinks will both be 145.825 MHz.
At all other times Sunsat will digipeat AX.25 UI packets in Mode B.
The uplink for both 1200 bit/s and 9600 bit/s data is 436.291 MHz.
Data from both uplinks are digipeated at 9600 bit/s on the 145.825
MHz downlink. Set your unproto paths to SUNSAT or APRSAT.
The complete voice schedule for the next few weeks can be found on
the Sunsat web page at <http://sunsat.ee.sun.ac.za/ham.htm>. Please
note that the voice passes just prior to the parrot operations (on
the 2nd and 3rd of October) may also be changed to Mode B (uplink
436.291 MHz, downlink 145.825 MHz). The parrot repeater schedule is
attached below (all times are UTC).
73 de ZR1CBC, Johann
+------------------------------------------------+
JG Lochner ESL, Universiteit van Stellenbosch
webtuiste: http://esl.ee.sun.ac.za/~lochner
+------------------------------------------------+
Japan
04/10/2000 09:06
05/10/2000 08:25
06/10/2000 07:45
07/10/2000 08:44
08/10/2000 08:04
09/10/2000 09:03
10/10/2000 08:23
Australasia
04/10/2000 07:46
05/10/2000 07:04
06/10/2000 08:06
07/10/2000 05:46
08/10/2000 08:25
09/10/2000 07:43
10/10/2000 07:01
South-Eastern Asia
04/10/2000 10:54
05/10/2000 11:52
06/10/2000 11:12
07/10/2000 12:11
08/10/2000 11:31
09/10/2000 10:51
10/10/2000 11:49
Southern Africa
04/10/2000 16:04
05/10/2000 15:24
06/10/2000 14:44
07/10/2000 15:42
08/10/2000 15:02
09/10/2000 16:01
10/10/2000 15:21
Europe
04/10/2000 17:22
05/10/2000 16:42
06/10/2000 17:41
07/10/2000 17:01
08/10/2000 18:00
09/10/2000 17:20
10/10/2000 16:39
South America
04/10/2000 21:00
05/10/2000 20:20
06/10/2000 21:18
07/10/2000 20:38
08/10/2000 21:37
09/10/2000 20:57
10/10/2000 20:17
North America
05/10/2000 00:04
05/10/2000 23:24
07/10/2000 00:23
07/10/2000 23:43
09/10/2000 00:42
10/10/2000 00:02
10/10/2000 23:22
[ Reply with "unsubscribe UIB/APRS" in subject line to leave list. ]
----------------------------------------------------------------------
Subject: Re: aprssig digest: September 27, 2000
From: Phil Reed <preed@dnaco.net>
Date: Thu, 28 Sep 2000 20:50:56 -0400
X-Message-Number: 22
How about setting the mailing list software to strip out HTML? Is that
possible?
>Subject: Re: Spam/Junk (Was: Teen mail)
>From: Stan Horzepa <stanzepa@mail2.nai.net>
>Date: Wed, 27 Sep 2000 22:06:57 +0000
>X-Message-Number: 32
>
>The settings of the SIG software are not "screwed up." There is no option to
>block messages "from automated systems/spam/other mailing lists."
---
...phil
"For a list of all the ways technology has failed
to improve the quality of life, press 3."
---
END OF DIGEST
Read previous mail | Read next mail
| |