OpenBCM V1.13 (Linux)

Packet Radio Mailbox

DB0FHN

[JN59NK Nuernberg]

 Login: GUEST





  
ZL3AI  > APRDIG   20.12.00 15:54l 208 Lines 7465 Bytes #999 (0) @ WW
BID : 35154_ZL3AI
Read: GUEST
Subj: TAPR Digest, Dec 18, 10/10
Path: DB0ABH<DB0RGB<OK0PPL<OK0PHL<SR6BOX<SR7BBS<VE1DRG<WB0TAX<KA6EYH<PP5BLU<
      PY3KW<ZL2TZE<ZL2TZE<ZL2WA<ZL2BAU<ZL3VML
Sent: 001218/2325Z @:ZL3VML.#80.NZL.OC #:51012 [Chch-NZ] FBB7.00g25 $:35154_ZL3
From: ZL3AI@ZL3VML.#80.NZL.OC
To  : APRDIG@WW


Subject: KAM v8.2 Problem
From: "Fred Coe" <wa0rto@cts.com>
Date: Mon, 18 Dec 2000 21:34:22
X-Message-Number: 46

Howdy,

Apparently my KAM w/8.2 needs to have the capacitors replaced again.

It has been almost a year since I last did this (I remember, cause it was 
last Christmas).

I know this is a fairly common problem with the older KAMs (and this one is 
13 years old) and I've replaced them a couple of times, however not as 
quickly as this time.  Since this TNC has been in service for APRS 24/7 
since last year, I was wondering if this is common replacement interval?

I appreciate your comments.

73

Fred
WA0RTO


----------------------------------------------------------------------

Subject: Re: KAM v8.2 Problem
From: Glenn Wiebe <gswiebe@mb.sympatico.ca>
Date: Mon, 18 Dec 2000 21:59:11 -0600
X-Message-Number: 47

What capacitors? Mine is 12 yrs. old, I've never replaced
any. It has been running 24/7 for at least the last 3-4 yrs.
Sounds like I'm pretty lucky.

Glenn...VE4GN

Fred Coe wrote:

> Apparently my KAM w/8.2 needs to have the capacitors replaced again.
> 
> It has been almost a year since I last did this (I remember, cause it was
> last Christmas).
> 
> I know this is a fairly common problem with the older KAMs (and this one is
> 13 years old) and I've replaced them a couple of times, however not as
> quickly as this time.  Since this TNC has been in service for APRS 24/7
> since last year, I was wondering if this is common replacement interval?

----------------------------------------------------------------------

Subject: RE: 9600
From: "Robert Donnell" <kd7nm@pugetsound.net>
Date: Mon, 18 Dec 2000 20:25:59 -0800
X-Message-Number: 48

Hi Bob, and all

I believe you're right about that Azden.  I'm not aware of anyone here in
the Seattle area that tried one though.

My first 9k6 radio was an Icom IC-290, which like SSB radios in general, has
a transmit IF strip as well as a receive IF strip (or they are combined).
To generate the FM signal, the carrier oscillator was deviated the - not the
PLL.

It so happens that the Icom IC-22S uses the same transmit scheme, and
therefore is able to generate a very good FSK signal.  While at AEA, I did
some non-rigorous on-air comparisons in performance, using the local 9k6
packet repeater and pinging my home station.  I also had a company IC-28
that I modified for PLL modulation.  For some reason, this radio had much
less degradation to the transmitted signal quality than most PLL modulated
radios, but it could still be observed.  Using 256-byte data payload
packets, on an omni antenna (IsoPole anyone?) I got the following results:

IC-22S @ 8 watts - 99%+ ping returns
IC-28A @ 25 watts - 95% ping returns
IC-22S @ 1.5 watts - 92% ping returns
IC-28A @ 5 watts - 85% ping returns

All test sequences at AEA were performed with the same antennas and TNCs,
deviation set identically on the two radios.  They were done during periods
of otherwise low use of the repeater, and each ping session ran every 5
seconds for at least 15 minutes.

The IC-28A was modified to bring out the discriminator, and modulation
applied to the PLL through a voltage divider, to avoid any noise or RF
coupling issues with the new cable out the back of the radio.

The IC-22S was modified to apply modulation at the deviation control wiper,
and receive signal is tapped on to the discriminator output ahead of the
audio shaping (de-emphasis) network.

The repeater is a modified GE Mastr II mobile radio, modified to keep the
receiver enabled, the PTT system continuously active, and the PTT function
from the TAPR modem used to operate the "unlock inhibit" function of the
radio's exciter, along with the usual direct FM modulation in the exciter.
It's receiver was modified in a manner similar to the MVP listed below.
Both stations were about 35 miles from the repeater site.  The
"carrier-to-keyup" delay on the repeater is about 70 mS, primarily due to
the delay in the modem while it's phase-locking the clock to the incoming
data.  The keyup delay is primarily absorbed by the delay in cycling bits
through the FIFO used in the regeneration process.

My home station was using a modified GE MVP commercial mobile radio.
Modifications were limited to direct FM modulation of its transmitter,
modifying the buffer amplifier following the discriminator to remove the
de-emphasis components, allowing proper drive to the RX modem, and changing
the power supply switching delay components to change the keyup delay from
70 mS to 7 mS, and the 7 mS RX delay altogether.  The TR relay operates in
about 3.5 mS.

The conclusion I drew from this at the time (about 1993) is that the quality
of the transmitted signal makes more of a difference than the signal
strength, where 9k6 signals are concerned.  And one of the most important is
that flat frequency response down to nearly DC is required to achieve a low
bit-error rate.  A PLL-modulated radio without dual-point modulation is
always going to compromise the performance of such a system.

73, Bob

-----Original Message-----
From: bounce-aprssig-17768@lists.tapr.org
[mailto:bounce-aprssig-17768@lists.tapr.org]On Behalf Of Bob Nielsen
Sent: Monday, December 18, 2000 4:28 PM
To: TAPR APRS Special Interest Group
Subject: [aprssig] RE: 9600


I recall that Azden had a radio about the same time which modulated a
fixed frequency oscillator, rather than the PLL, and used a heterodyne
circuit.  I never saw one, but heard that they had achieved fairly good
9600 performance, as do many of the all-mode radios which do the
modulation on a fixed oscillator.

Bob



----------------------------------------------------------------------

Subject: Help for KB8ROP
From: Qrpvhf@aol.com
Date: Mon, 18 Dec 2000 23:35:13 EST
X-Message-Number: 49

There is a guy near Cleveland,Oh area callsign KB8ROP who is trying to setup 
a weather station under WinAPRS that could probably use some help.

He has shown up twice today on our local screens as a weather station. First 
his position was near Waynesburg,PA then it moved to near Kingwood,WV on the 
WV/MD border.

Jacob Tennant,K8JWT

----------------------------------------------------------------------

Subject: Re: KAM v8.2 Problem
From: Skip Allison <sallison@megsinet.net>
Date: Mon, 18 Dec 2000 23:23:43 -0600
X-Message-Number: 50

Mine is almost 15 years old.  I replaced my caps about 8 years ago and
haven't had a problem since.  Did you get your replacement caps from
Kantronics?  Maybe they were the same kind.  I just pulled some out of
my parts bins.  Completely different kind, but same value.  

Skip
K9SA

Fred Coe wrote:
> 
> Howdy,
> 
> Apparently my KAM w/8.2 needs to have the capacitors replaced again.
> 
> It has been almost a year since I last did this (I remember, cause it was
> last Christmas).
> 
> I know this is a fairly common problem with the older KAMs (and this one is
> 13 years old) and I've replaced them a couple of times, however not as
> quickly as this time.  Since this TNC has been in service for APRS 24/7
> since last year, I was wondering if this is common replacement interval?
> 
> I appreciate your comments.
> 
> 73
> 
> Fred
> WA0RTO
> 
> ---
> You are currently subscribed to aprssig as: sallison@megsinet.net
> To unsubscribe send a blank email to leave-aprssig-18700I@lists.tapr.org
> Questions regarding the SIG go to the SIG administrator: wa1lou@tapr.org



---

END OF DIGEST



Read previous mail | Read next mail


 16.11.2026 20:08:39lGo back Go up