| |
PA2AGA > PACDIG 06.12.99 10:03l 158 Lines 4553 Bytes #-9639 (0) @ EU
BID : PR_99_287B
Read: DL6KCF GUEST
Subj: PacketRadioDigest 99/287B
Path: DB0AAB<DB0PV<DB0MAK<OK0PKL<OK0PPR<OK0PHL<OK0PBB<OK0PAB<HA5OB<HA3PG<
SV1AAW<EA7URC<PE0MAR<PI8VNW
Sent: 991206/0501Z @:PI8VNW.#ZH2.NLD.EU #:29810 [HvHolland] FBB7.00g $:PR_99_28
From: PA2AGA@PI8VNW.#ZH2.NLD.EU
To : PACDIG@EU
Received: from pa2aga by pi1hvh with SMTP
id AA25507 ; Mon, 06 Dec 99 04:30:58 UTC
Received: from pa2aga by pa2aga (NET/Mac 2.3.67/7.5.3) with SMTP
id AA00017101 ; Sat, 04 Dec 99 23:49:01 MET
Date: Sat, 04 Dec 99 23:38:35 MET
Message-Id: <pr_99_287B>
From: pa2aga
To: pr_broadcast@pa2aga
Subject: PacketRadioDigest 99/287B
X-BBS-Msg-Type: B
Icom IC-uSAT FM HT $100
Icom IC-255A 2 meter Transceiver $150
Ampex Model 620 Amplifier $50
Iomega Ditto Easy 800 Tape Drive/software $40
Radio Shack 3A 13.8V Regulated Power Supply $35
Belmoor 7A 13.8V Regulated Power Supply $35
Astron 20 Amp Regulated Power Supply $75
Signal Corps Keyer Type J-36 (Lionel) $100
Bencher Iambic Keyer $60
Akai GX-625 Reel Tape Recorder $50
Realistic 909 Reel Tape Recorder $50
Realistic SCT-30 3-Head Tape Recorder $35
Reel to reel Tape, new, 7" and 10" $2.50/$5
All prices plus shipping
Chris Jespersen K2OG
Bridgeton, NJ
856-451-2710
>.
------------------------------
Date: Fri, 26 Nov 1999 09:44:31 -0800
From: kk1a <kk1a@efn.org>
Subject: FILTER SOURCES Re: Annoying ham operator
Hi,
There are several 'Hi Pass' filters you can put between yout TV antenna and
the TV that will block the lower ham frequencies. Look to
Radio Shack or Amateur Electronics Supply (800)558-0411
Speaker Wires act as antennas. putting a .01 uFd ceramic cap Across the
terminals will reduce the effect of RF on speakers
There are 'Low Pass' filters that can be put on the radio transmitter,
made by Drake, Hi-Gain, MFJ, and others. Ask at (800) above
A Good Ground at Both Places is probably a real big help. The 'Blocked'
signals need a place to go to. Check the connections in your house where
the Power Ground is established. Electrical Code says there should be a
ground
for each section (100 sr ft ?). If its dirty, clean it. Questions? Ask an
Electrician.
There are LOTS of other technical items. Cooperation & realizing that The
Radio Station may be meeting ALL of it's requirements Already, and the
'plastic boxes' that provide no shielding is what a lot of radios/TV's
are built inside of. so ...
regards Karl KK1A
QTC QSP Via CW/SSB/FM/Packet/Inet/USPS/Bicycle Mobile
The day after Thanksgiving - shop till you drop, or in the northwest,
shop till you drip.
On Thu, 25 Nov 1999, Scott Wolfe wrote:
]Reply-To: Scott Wolfe <shantoa@woflenet.com>
]Newsgroups: alt.ham-radio.packet
]Subject: Re: Annoying ham operator: another thing.
]Well I called while it was happening one time and asked his wife if he was
]on and she said yes. In fact she was the one that said there was such a
]filter as least she thought so.
>.
------------------------------
Date: Wed, 24 Nov 1999 21:09:25 -0500
From: "Anthony Cash" <kd4k@ga.prestige.net>
Subject: Kenwood TS-570D and Kam
"Anthony Cash" <kd4k@ga.prestige.net> wrote in message news:...
> I have 2 problems with my TS-570D (not G model) and the Kantronics Kam.
>
> 1. If I turn the Kam on and the 570 is already on it will key the
> transmitter. If I turn the Kam
> off and back on again the 570 will return to receive. Otherwise the
> keying works fine.
>
> 2. The 570 is an early model SN 80600xxx and has had this problem every
> sense it
> was new.
> A. Kam is hooked to 570 via the 13 pin din connector on rear panel with
3
> conductor
> shielded wire.
>
> a. I have the Kam turned on.
> b. Turn on the 570
> c. Try to transmit packet, 570 keys up but no output.
> d. Go to menu #33 (it is set to 1)
> e. press up or down button and then back to 1
> f. Try to transmit packet again. Now 570 transmits fine with full
> output
> and will keep on doing fine until I turn it off. When I turn it
> back on I have to
> go through the whole thing again. Menu #33 DOES NOT change, it
> stays where
> I put it.
>
> Any help would be greatly appreciated
> 73 de Tony, KD4K
>
>
>
>.
------------------------------
Date: Fri, 26 Nov 1999 08:57:32 -0800
From: "Bud Turner" <vvatc@whidbey.net>
Subject: R0MIR QSL Card
I finally figured out why my web page wasn't displaying the pictures. I
fixed it if anyone wants to take a look.
http://www2.whidbey.net/vvatc/r0mir.htm
73,
Bud
>.
------------------------------
End of Packet-Radio Digest V99 #287
******************************
You can send in your contribution to this digest by
sending an e-mail to: packet-radio@pa2aga.ampr.org
or (via BBS-net) to: praga@pi8vnw.#zh2.nld.eu
Read previous mail | Read next mail
| |
