| |
VK3JMA > LINUX 25.07.03 04:48l 67 Lines 1306 Bytes #999 (0) @ WW
BID : C50182VK3JMA
Read: GUEST DB0FHN DL7NDR
Subj: PCMCIA Help!!!
Path: DB0FHN<DB0RGB<OK0PPL<DB0RES<ON0AR<ZL2BAU<VK6HGR<VK3AYM<VK3DSE
Sent: 030724/0842Z @:VK3DSE.#MEL.VIC.AUS.OC #:54247 [Narre Warren] FBB7.00g25
From: VK3JMA@VK3DSE.#MEL.VIC.AUS.OC
To : LINUX@WW
Hello,
Ok, the story.....
I install RedHat 7.0 from a fresh on my 166Mhz IBM Think Pad laptop.
I do and install everything and it goes well.
I set up networking through my Xircom PCMCIA ethernet card, configure
SAMBA, Gateway through my other LINUX system for internet connectivity,
no problems, all is fine in Linux Land.
Suddenly I get an idea to compile a kernel with AX25 stuff enabled. A
task that I have done many times before......
make mrproper
make menuconfig
Enable this, enable that.
make dep
make clean
make bzImage
make modules
make modules_install
No problems, I read in the PCMCIA_HOWTO to cd to the pcmcia-3.1.x
directory and ...
make config
make all
make install
do a depmod
edit /etc/lilo.conf
run lilo
reboot
select new kernel image, seems to be no problems yet when starting pcmcia
services it fails in setting up the card.
When I read /var/log/messages it states that it could not find the module
for the xircom card in /lib/modules/<kernel>/pcmcia but I know it is
there.
Please, this has driven me crazy for ages, can anyone assist in
suggestions, answers, advice.........
Regards
Mark
-------------------------------
73 - Mark, VK3JMA
email: vk3jma@net2000.com.au
-------------------------------
Read previous mail | Read next mail
| |
