| |
ZL4PZ > C64 24.10.03 17:02l 60 Lines 2160 Bytes #999 (0) @ WW
BID : 527_ZL4PZ
Read: DB0FHN GUEST
Subj: C64 Ref Guide (2)
Path: DB0FHN<DB0RGB<OK0PPL<DB0RES<ON0AR<WB0TAX<W7NTF<VK3TE<VK3KAY<ZL2TZE<
ZL2TZE<ZL2WA<ZL4AA<ZL4PZ
Sent: 031024/0527Z @:ZL4PZ.#90.NZL.OC #:527 [Fairfield] FBB7.00g $:527_ZL4PZ
From: ZL4PZ@ZL4PZ.#90.NZL.OC
To : C64@WW
Page 2 C64 Quick Reference
(5) Your options at this stage are:
to load the program, press [C=]
to abandon the program press [RUN/STOP]
to load next program, press any other key.
Doing nothing will cause a delay after which the next program will load.
If the program was loaded to autorun (section 2 above), the program will
load and then run by itself.
However, if you have used any other two methods of loading, you will have
to type in the following to get the program to run: RUN [RETURN)
(C) USING DISK DRIVES:
(1) Open the disk drive door by pressing the catch lightly. Any disk
already in the drive will be ejected.
(2) Place the disk in the drive with the label facing upwards, closest
to you on the right side of the disk as you hold it. That is, with
the elongated slot facing towards the disk drive opening.
(3) GENTLY push the disk all the way in the drive until it clicks in
place and does not spring out.
(4) Close the latch door by pulling downwards until the latch clicks
into place.
Always remove disks before turning the drive on or off !!
Failure to do so could result in the programs on the disk being wiped
completely !!
NEVER REMOVE DISK FROM THE DRIVE WHILE RED LIGHT IS ON!!!
To do so could result in the programs on the disk being wiped completely !!
(D) DISK COMMANDS FOR 1541 DISK DRIVE:
(1) LOADING A PROGRAM FROM DISK
(a) BASIC programs:
LOAD "Program name",8 [RETURN]
RUN [RETURN]
(b) MACHINE LANGUAGE programs:
LOAD "program name",8,1 [RETURN]
SYS NNNNN [RETURN)
where NNNNN is a number, usually 49152
Some machine language programs run themselves automatically, for example
commercial software.
(2) SAVING A PROGRAM TO DISK:
(a) BASIC programs:
SAVE `program name",8 [RETURN]
(b) MACHINE LANGUAGE programs:
SAVE "program name,8,1 [RETURN]
YOU CANNOT SAVE PROGRAMS TO UNFORMATTED DISKS!!!
Read previous mail | Read next mail
| |
