OpenBCM V1.13 (Linux)

Packet Radio Mailbox

DB0FHN

[JN59NK Nuernberg]

 Login: GUEST





  
DJ6PC  > AMTOR    14.11.97 15:17l 48 Lines 2036 Bytes #-10599 (0) @ EU
BID : 14B713DB0GV
Read: DL6OK DC0VD GUEST
Subj: re: amtor help (g0vss)
Path: DB0ZDF<DB0GV
Sent: 971114/1413z @:DB0GV.#HES.DEU.EU [Frank4t/Mtl OP:DF5FF] $:14B713DB0GV
de DJ6PC @ DB0GV.#HES.DEU.EU   (Alfred)

to AMTOR @ EU

Hi Ray and other readers of this message,

the fact that your problem only arises when you call on arq
and not when you are called by other stations clearly indicates
that your rx recovery time is too long, as you already found out
by listening. So you must modify your ft767gx to decrease the
rx recovery time. Hints for such modification are given in some
mailboxes under headers like rigmods or yaesu, and also on the
internet. If you cannot find them, send me a message, and i will
try and find them for you.

You may ask why I am so sure? Why is there no problem when
somebody else calls you?
Because then the time between your transmission and the arrival
of the answer is longer. If you have originated the connection
your station is the master and the other station the slave. After
the slave has received your message it waits a few milli-seconds
(the tx delay) before it sends. A few milli-seconds later (i. e. 
the time needed to cover the distance to your antenna) this answer
reaches your station. If your rx is not yet ready then, it will not
receive the first part of the answer, and there you are.
If the other station originates the call, things are different.
After you (the slave) have answered and the other station (the 
master) has received your answer, it waits till the end of the
time-slot before it sends the next message. This time is usually
much longer in order to enable long distance qsos.

To verify this you can make two tests:
1. Try dx qsos (the longer the distance the better). You should 
have no problems then even if you originated the connection.
2. Make a sked with someone who can prolong his tx delay to, let's
say, 150 msecs. Again you should have no problems. But with such a
long tx delay the other station will have problems with dx qsos.
That is why the tx delay should be as short as possible.

I hope I could help you or at least show you the way to further 
help.

Good luck and 73 de Alfred DJ6PC@dk0mav.#nds.deu.eu

answer 





Read previous mail | Read next mail


 21.11.2026 19:13:08lGo back Go up