| |
CX2SA > SATDIG 04.07.05 08:30l 146 Lines 5481 Bytes #999 (0) @ WW
BID : 6171_CX2SA
Read: GUEST
Subj: AMSAT-BB-digest V2004 #777 6/7
Path: DB0FHN<DB0FOR<DB0SIF<DB0FHK<DB0FBB<DB0IUZ<DB0GOS<DB0RES<DK0WUE<7M3TJZ<
HS1LMV<CX2SA
Sent: 050704/0717Z @:CX2SA.LAV.URY.SA #:6171 [Minas] FBB7.00e $:6171_CX2SA
From: CX2SA@CX2SA.LAV.URY.SA
To : SATDIG@WW
Message: 21
Date: Sun, 03 Jul 2005 19:56:41 -0400
From: W4UPD <w4upd@bristor-assoc.com>
Subject: Re: [amsat-bb] 5400 and Nova
Lawn, Richard wrote:
>I've been having trouble again with my EL rotor (G-5400B) after rebuilding it
and replacing the pot. When I attempt to calibrate things under Nova using the
SASI interface the Raw value jumps all over the place. It was briefly stable
and then went nuts again. I hate the thoughts of tearing it down again or
sending it off to Yaesu this time for repair but may not have any choice. Any
advice?
>Rick
>W2JAZ
>----
>Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
>Not an AMSAT member? Join now to support the amateur satellite program!
>To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
>
>
>
>
>
Your problem may be the calibration pots within the contol box. It is
not uncommon to have them go and need to be replaced. I had to replace
mine on both azimuth and elevation and then everything was fine.
Reid, W4UPD
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
------------------------------
Message: 22
Date: Sun, 3 Jul 2005 22:24:24 EDT
From: Ka8syx2003@aol.com
Subject: [amsat-bb] Marked differences in published elements?
Folks,
Because I've been between home qths lately, I haven't had opportunity to be
QRV, but was poking around on the computer this evening. During past QSOs with
some of you, I've mentioned that I pull all of my predictions from WinOrbit
3.6 to printed ephemeris and hand carry them outside where I set up for a given
pass. Tonite I made side by side comparisons between the predictions I was
getting off of Satscape 2.02 pro and off the WinOrbit. I like Satscape because
it provides some "sexier" views and is more "real-time" feeling. Anyhow, I
was watching what FO-29 was doing this evening during an approximately 0140 to
0200 pass on both programs and discovered marked differences in predicted
location, variances of several degrees in alt, az and lat/lon subsatellite
point.
Comparing the elements that I routinely download from AMSAT with those the
Satscape took via "internet update" from Celestrak illustrated a possible cause
of the differences:
DECODE 2-LINE ELSETS WITH THE FOLLOWING KEY:
1 AAAAAU 00 0 0 BBBBB.BBBBBBBB .CCCCCCCC 00000-0 00000-0 0 DDDZ
2 AAAAA EEE.EEEE FFF.FFFF GGGGGGG HHH.HHHH III.IIII JJ.JJJJJJJJKKKKKZ
KEY: A-CATALOGNUM B-EPOCHTIME C-DECAY D-ELSETNUM E-INCLINATION F-RAAN
G-ECCENTRICITY H-ARGPERIGEE I-MNANOM J-MNMOTION K-ORBITNUM Z-CHECKSUM
AMSAT.ORG (05181.AMSAT)
FO-29
1 24278U 96046B 05181.59521482 .00000020 00000-0 53797-4 0 9873
2 24278 098.5427 229.3523 0351282 141.4784 221.1994 13.52914251438002
www.celestrak.com/NORAD/elements/amateur.txt
FO-29
1 24278U 96046B 05184.18367414 -.00000027 00000-0 60488-5 0 9890
2 24278 98.5431 231.5914 0351209 134.7619 228.2674 13.52913791438356
There are some big variations between the two sets. I realize that the AMSAT
numbers are for Julian 05181 and the Celestrak figures are apparently three
days fresher, but can that small difference (when the Satscape launchpad
suggests a user only needs to correct/update his keps once a month or at most
frequently every few weeks) cause such wide discrepancies?
Which can I believe? Being an older app, should I just toss WinOrbit 3.6 out
in favor of the Satscape? As a control, I also compared both realtime
predictions, as they were occurring, with NASA J-Pass 2.0's prediction for this
same
pass of FO-29 and its figures came much closer to the Satscape predictions.
All other parameters (geo location of observer, etc.) were identical within a
few thousandths of a degree and of similar precision.
Comments, replies, am I just doing something wrong? Thanks for any offered
insights!
73, Ray KA8SYX
Jacksonville, FL EM90ee (formerly of Big Pine Key, FL EL94hr ;>)
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
------------------------------
Message: 23
Date: Sun, 3 Jul 2005 21:49:19 -0500
From: "Walter Holmes" <walterh@k5wh.net>
Subject: RE: [amsat-bb] AO-51 UP AND RUNNING AGAIN
Outstanding news !!
Thanks for the update Angelo..
And all the best to the Echo Team for a great recovery..
Walter/K5WH
- -----Original Message-----
From: owner-AMSAT-BB@amsat.org [mailto:owner-AMSAT-BB@amsat.org] On Behalf
Of Angelo Glorioso
Sent: Sunday, July 03, 2005 9:08 PM
To: amsat-bb@amsat.org
Subject: [amsat-bb] AO-51 UP AND RUNNING AGAIN
Thanks to the hard work of the Echo Command Team, AO-51 is up and running
again tonite.
Great Job Guy!!!!
73 de Angelo
- ---------------------------------------------------------
If you don't ask, you will never know!!
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
Read previous mail | Read next mail
| |