OpenBCM V1.07b12 (Linux)

Packet Radio Mailbox

DB0FHN

[JN59NK Nuernberg]

 Login: GUEST





  
G8MNY  > TECH     21.08.20 09:25l 112 Lines 4533 Bytes #999 (0) @ WW
BID : 2237_GB7CIP
Read: DJ6UX GUEST OE7FMI
Subj: What is Multiplexing?
Path: DB0FHN<OE2XZR<OE5XBL<F1OYP<ON0AR<OZ5BBS<CX2SA<N9PMO<JE7YGF<GB7CIP
Sent: 200821/0815Z @:GB7CIP.#32.GBR.EURO #:2237 [Caterham Surrey GBR] $:2237_GB
From: G8MNY@GB7CIP.#32.GBR.EURO
To  : TECH@WW

By G8MNY                            (Updated Dec 08)
(8 Bit ASCII graphics use code page 437 or 850, Terminal Font)

What is Multiplexing
This is where several circuits or channels use the same route/system.

There are only 3 types of Multiplexing or MUX.
1/ Space Division
2/ Frequency Division
3/ Time Division

1/ Space Division Multiplexing
This is not obvious, but is the simplest, it is where the circuits occupy
different physical space.

Examples are multi            .---.
conductor cable              /:::::\  : = Circuit pairs 
where each circuit          ³:::::::³
is on different              \:::::/Cable
conductors.                   '---'

 X Band  X Band  X Band         Another example would
   Sat A  Sat B  Sat C          be Satellites, where
       \' . |'ú. /ú             bands of frequencies
        \   |ú  /ú.'.           or channels are reused
         \  |  /' .'ú:.         on satellites on
       Different    'Same       different beam headings.
      Dish Angle    Routes      e.g. each 1.5ø for comms Sats.

2/ Frequency Division Multiplexing
This is where the channels are split up on different frequencies like on a
radio. e.g. they all share the same aerial. Cable TV & old cable SSB telephone
system cram 1000s of channels down a coax this way.

 ³ch1 ch2 ch3 ch4 ch5 ch6 ch7 ch8     ch7500
 ÀÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁÄÄÄÁ/ /ÄÁÄÄÄ
     4k  8k 12k 16k 20k 24k 28k 32k .... 30MHz

Some high capacity Fibre optics systems still use it with different coloured
light to multiply the fibre capacity 1000s of times.

3/ Time Division Multiplexing *
This is where channel is swapped for another normally in sequence. Simplest
example would be day & nighttime TV by 2 different stations. Further example is
Stereo Radio, where the left & right channels are swapped over at 76000 times a
second. Note a synchronisation system is needed to maintain channel separation.

          76kHz
Left ÄÄo  Switch
        \,_______________________ÚÄÄÄÄÄ¿    ÚÄÄÄÄÄÄÄÄ¿
RightÄÄo  /|\                    ³ Add ÃÄÄ>Ä´ 53kHz  ÃÄÄÄ> to Tx
           ³   ÚÄÄ¿   ÚÄÄÄÄÄÄÄ¿  ÀÄÄÂÄÄÙ    ³Low Pass³
  76kHz >ÄÄÁÄÄÄ´ö4ÃÄÄÄ´ 19kHz ÃÄÄÄÄÄÙ-20dB  ³ Filter ³
               ÀÄÄÙ   ³Filter ³             ÀÄÄÄÄÄÄÄÄÙ
                      ÀÄÄÄÄÄÄÄÙ
A switched audio system like this used to be used for busy transatlantic phone
calls, only switching in the those people who where actually talking.

More complex example is DAB/Digital TV where quality/digital statistical
multiplexing determines which channel get sent in the data stream next.


All 3 at once!
It is possible to get confused if more than one multiplex method is used.

Channels  __________
---------´  Pulse   ³           _________
---------´   Code   ³ DIGITAL  ³Coloured ³           _____________
---------´ModulationÃÄÄÄÄÄÄÄÄÄÄ´  Light  ³FREQUENCY ³Multi Strand ³HIGH
---------´ & Time   ³         >´FrequencyÃÄÄÄÄÄÄÄÄÄÄ´ Fibre Optic ³CAPACITY
---------´ Division ³   Other >´Division ³   Other >´Cable. Space ³TRUNK
---------´Multiplex ³   Inputs>´Multiplex³  Inputs >´Div Multiplex³ROUTE
         ÀÄÄÄÄÄÄÄÄÄÄÙ          ÀÄÄÄÄÄÄÄÄÄÙ          ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÙ

Then huge capacities are possible with all 3 in use.

CONCLUSION
Quite often several of the above are used at once all invisibly computer
controlled. The advantage is more efficiency use of a route, but as a cost of
far more complexity & reduced reliability. E.g. a DAB Radio is running the
equivalent of a pentium processor to decode the bit stream.

QUESTION.
Now just ponder this:- Take two balanced 600ohm lines (diagonals of a quad
cable) & using balanced transformers (or op amps) make a 3rd circuit using the
centre tap phantoms...

          ___    _________________________________    ______
Circuit 1    )||(____                         ____)||(
          ___)||(____³_______________________³____)||(______
                     ³                       ³
          ___    ____³                       ³____    ______
Phantom      )||(            Balanced             )||(
Circuit   ___)||(____          Quad           ____)||(______
                     ³         Cable         ³
          ___    ____³_______________________³____    ______
Circuit 2    )||(____³                       ³____)||(
          ___)||(_________________________________)||(______


How is this 3rd Phantom circuit multiplexed, Space, Frequency or Time?


* See my TECH bul on "FM Stereo Radio Principles" 

Why don't U send an interesting bul?

73 de John G8MNY @ GB7CIP


Read previous mail | Read next mail


 05.11.2024 16:23:29lGo back Go up