| |
G8MNY > TECH 05.12.03 09:18l 39 Lines 1631 Bytes #999 (0) @ WW
BID : 28910_GB7CIP
Read: OE3KLU DB0FHN GUEST OE7FMI
Subj: 23cms Filter
Path: DB0FHN<DB0FOR<DB0SIF<DB0FSG<DB0RGB<OK0PPL<DB0RES<ON0BEL<CT4DK<ZL2TZE<
IK1ZNW<GB7CRV<GB7CIP
Sent: 031205/0116Z @:GB7CIP.#32.GBR.EU #:28910 [Caterham] $:28910_GB7CIP
From: G8MNY@GB7CIP.#32.GBR.EU
To : TECH@WW
By G8MNY
Here is a simple filter that will remove most unwanted signals often found as
unwanted images in 23cms Rx. eg UHF TV signals x2. It will also give some
static protection for preamps as the double tuned line is grounded, but the
loss can be as high as 2dB depending on materials! Bandwidth is quite narrow &
the filter will need tuning top to bottom of 23cm band. It is not suitable for
Tx over 1-2W due to the trimmer losses.
The I/P & O/P can be coax leads soldered straight to the box & line or BNC/F
connectors etc.
<-1.5cm-> <-1.5cm->
Coax or BNC Coax or BNC
^ ======= ! ======================== ! ========
1.5cm ³³_________________________________________³³
v ³³ [^] Brass strip ³³\...End Wall
====================! !======================
0.5-3pF \..Side Wall
< - - - - - - - - 8cm - - - - - - - - - - - >
It is made from double sided PCB 2cm tall all seam soldered up with the bottom
& end pieces slightly larger to allow inside & outside soldering of the side
walls. Leave the lid off until after the initial tune up.
The brass strip is 4mm wide (can be thick copper wire) & is soldered to both
end walls. The trimmer is a bolt in type, but soldered in ceramic ones from old
mechanical TV tuners will do.
Once it is tuning well, tack solder the lid on & re-tune, you should have
slightly better Q, make sure the tuning is OK before properly soldering up the
seam.
/QSL
73 De John, G8MNY @ GB7CIP
Read previous mail | Read next mail
| |
