| |
ZL3AI > APRDIG 29.06.03 10:35l 47 Lines 1340 Bytes #999 (0) @ WW
BID : 1540-ZL3AI
Read: GUEST
Subj: TAPR Digest, Jun 25, 2/2
Path: DB0FHN<DB0RGB<OK0PPL<RZ6HXA<HA3PG<WB0TAX<N1UAN<ZL2BAU<ZL3VML
Sent: 030628/1120Z @:ZL3VML.#80.NZL.OC #:3178 [Chch-NZ] FBB7.00i $:1540-ZL3AI
From: ZL3AI@ZL3VML.#80.NZL.OC
To : APRDIG@WW
Subject: Cannot get a Kenwood TH-D7 to work with a Magellan GPS
From: "Micah Goodman" <kd7khu@mail.com>
Date: Wed, 25 Jun 2003 21:1:7
X-Message-Number: 13
Hello
I've been trying to get my thd7a to receive anything other than blinking
degrees symbols reading all 0's in the position screen, with my magellan
color tracker gps, but have had no luck.
I talked with kenwood's tech support, but they have no idea, said try
here.
I've checked the baud it's 4800(on the GPS and GBaud on the TNC) map datum
is wgs84 coord system is set to Lat/Lon hh/mm/ss NMEA 2.1 format
it definetly sends data out readable data at 4800 baud out of the gps, I
used two wires hooked from gps ground to pin 5 gnd and gps tx to 3 rx on a
9 pin serial connector.
I've tried 9600 works find through the serial, just blinks on the d7. Tried
both other 1.5 NMEA formats.
Tried changing coord to utm and also hh/mm/sss
Any advice would be greatly appreciated
Micah
----------------------------------------------------------------------
Subject: Re: Cannot get a Kenwood TH-D7 to work with a Magellan GPS
From: "Micah Goodman" <kd7khu@mail.com>
Date: Wed, 25 Jun 2003 21:14:30
X-Message-Number: 14
PS
The D7 is not upgraded(1998 TNC), and I have tried a full reset on the d7
many times
---
END OF DIGEST
Read previous mail | Read next mail
| |
