OpenBCM V1.13 (Linux)

Packet Radio Mailbox

DB0FHN

[JN59NK Nuernberg]

 Login: GUEST





  
ZL1AJP > QRP      16.10.99 14:20l 23 Lines 1117 Bytes #-9893 (0) @ WW
BID : 260370ZL1AJP
Read: DL2MHG GUEST
Subj: T-KIT 1380 improvements.
Path: DB0ZKA<DB0ABH<DB0SRS<DB0AIS<DB0IZ<ON6AR<WB0TAX<VK7AX<N8ZFM<ZL2TZE<
      ZL2TZE<ZL2WA<ZL1AM
Sent: 991012/1825Z @:ZL1AM.#01.NZL.OC #:24818 [Whangarei ARC] FBB7.00f
From: ZL1AJP@ZL1AM.#01.NZL.OC
To  : QRP@WW


For those of you who have the Ten-Tec 1380 QRP CW rig, I have found a
couple of things that improve the operaton of it.
Firstly the two resistors R26 and R28 at the top of "Assembly page 36" are
transposed. R26 should be 100k and R28 should be 1meg. This makes the AGC
work one heck of a lot better.
Now I (and several others) have found that the Side tone has severe key
clicks on it. The problem appears to be that the audio amp has far too
much gain. By knocking back the feedback cap C6 from 10uf to .47uf , a
couple of us have solved the problem. There is plenty of audio gain left,
and the audio pot has a far more linear response as well.
Once the cap has been replaced, adjust the sidetone pot until the sidetone
level just starts to rise and leave it at that. Probably best adjusted
while listening on an aerial to allow for the inherent noise on
80m...otherwise the sidetone appears a bit weak.
Hope this may help any other users of this great little set. If you don't
own one and are interested in QRP CW I can heartily recomend one.
C U on /QRP
de Ron ZL1AJP


Read previous mail | Read next mail


 16.11.2026 19:42:38lGo back Go up