| |
DJ0XC > KAM 24.10.95 00:59l 48 Lines 1080 Bytes #-11214 (0) @ EU
BID : DGX6ZP_DB0GR
Read: DF7ML GUEST
Subj: KAM and HF-Xcvr Freq Calibration
Path: DB0AAB<DB0MWS<DB0LAN<DB0RGB<OK0PPL<OK0PKL<DB0JES<DB0GR
Sent: 951023/2115Z @:DB0GR.#BLN.DEU.EU [Berlin-BBS OP:DL7QG] DP4.08 $:DGX6ZP_DB
From: DJ0XC @ DB0GR.#BLN.DEU.EU (Bob)
To : KAM @ EU
Info: Upload without password authentication
\\\
KAM, HF-Tranceiver frequency calibration
According to a letter from Kantronics, you can set your tranceiver memories
to the exact mark frequency using your frequency counter and by following
the these steps: connect freq ctr to an separate antenna.
After xcvr warm-up;
1. Set transmitter power low, RIT + XIT to OFF
2. Set VFO to approx freq. to be stored
3. Type cmd "Diddle OFF"
4. type cmd "RTTY"
5. type cmd "CTRL T" = Transmit (red lite on KAM on + xcvr transmits mark)
6. adjust vfo freq to exact mark freq by observing the freq ctr (not the dial)
7. press write on xcvr to store freq in appropriate memory (see xcvr manuel)
8. set other freqs in other memories as in 6, 7 and 8 above
9. type "CTRL CX" to return to normal operation
10.now all your memories are on the exact mark freqs of BBS; you won't have
to search anymore!!!
Have fun with Pactor, Amtor and G-tor Hi
73 de DJ0XC at DB0GR.#BER.DEU.EU QRV 7038.5M
NNNN
+?
\\\
Read previous mail | Read next mail
| |
