| |
KJ6NKR > KPCTNC 02.10.16 10:56l 22 Lines 703 Bytes #-3078 (0) @ WW
BID : 39106_WA6EWV
Read: GUEST DK3UZ
Subj: MYPBBS Help
Path: DB0FHN<DB0PM<OE5XBL<F1OYP<IW8PGT<CX2SA<GB7CIP<I0OJJ<N6RME<WA6EWV
Sent: 161002/0930Z @:WA6EWV.#NCA.CA.USA.NOAM #:39106 [Lake Tahoe] FBB7.00i
From: KJ6NKR@WA6EWV.#NCA.CA.USA.NOAM
To : KPCTNC@WW
Hello!
Using an older Kantronics KPC2 TNC here.
Have it setup with PBBS as KJ6NKR-1 and I'm curious if there is a way to access the PBBS through the computer attached to the T
NC. In the manual it says to just hookup the serial cable to the TNC, then type
the typical connect command, like you would connect to another PBBS.
In my case the MYPBBS would be:
C KJ6NKR-1
Entering this command on the TNC command prompt will then Tx the TNC and try to connect with KJ6NKR-1 through radio, so it neve
r enters into the PBBS.
Is there a way to access the PBBS on the TNC locally without having to access through another TNC/Radio?
73 Jeff
KJ6NKR
Read previous mail | Read next mail
| |
