| |
OE5FNO > MODS 29.06.03 19:32l 34 Lines 1515 Bytes #999 (0) @ WW
BID : T63OE5XBR019
Read: GUEST DB0FHN
Subj: FT-900 Frequency Expansion Information
Path: DB0FHN<DB0RGB<OE5XBL<OE2XUM<OE5XBR
Sent: 030629/1739z @:OE5XBR.#OE5.AUT.EU [FIRAC-BBS JN78dh OP:OE5FNO] BCM1.42
From: OE5FNO @ OE5XBR.#OE5.AUT.EU (Mario)
To: MODS @ WW
Yaesu U.S.A.
Amateur Products Division
Technical Support
Model: FT-900
Date: 24 August 1994
Original Freq. Range: 160-10M (Ham)
New Freq. Range: 1.8-29.99MHx TX
Important Notice Regarding Disclosure Restrictions
This information is autorized for distribution only to individuals who are
members of the U.S. Military Affiliate Radio System, Civil Air Patrol, or
other government services specifically permitted by the FCC to use non-type
accepted equipment such as that
Remove the two screws from the top cover, and the two screws from the top
rear area of the rear panel, so as to allow the top cover/heat sink to be
slid slightly toward the rear. The objective is to be able to see into the
CNTL-1 Unit, which is the i
Locate test points TP3001 and TP3002 on the CNTL Unit. They are located near
the top edge of the board, in the center from left to right. With the
transceiver still turned off, connect a jumper (alligator clip is ok) between
these 2 test points.
Hold in the following 4 buttons: [PROC], [ATT], [IPO], and [NB]. While
holding them in, turn the transceiver on. Release the buttons.
The display will indicate OFF. Turn the VFO dial slowly until the display
reads ON.
Press the [PROC] button to write the new instructions to EEPROM.
Remove the jumper across the test points.
Replace the case screws. Mod is now complete.rea of the rear panel, so as to
allow the top cover/heat sink to be slid slightly toward the re
Read previous mail | Read next mail
| |
