OpenBCM V1.13 (Linux)

Packet Radio Mailbox

DB0FHN

[JN59NK Nuernberg]

 Login: GUEST





  
CX2SA  > SATDIG   07.07.05 14:45l 125 Lines 4757 Bytes #999 (0) @ WW
BID : 7676_CX2SA
Read: GUEST
Subj: AMSAT-BB-digest V2004 #782 1/8
Path: DB0FHN<DB0MRW<DB0WUE<DK0WUE<7M3TJZ<EA5AKC<CX2SA
Sent: 050707/1330Z @:CX2SA.LAV.URY.SA #:7676 [Minas] FBB7.00e $:7676_CX2SA
From: CX2SA@CX2SA.LAV.URY.SA
To  : SATDIG@WW


AMSAT-BB-digest        Thursday, July 7 2005        Volume 2004 : Number 782

In this issue:

1: Re: [amsat-bb] Airline Carryon
2: [amsat-bb] www.amsat.org/amsat-new/echo/ModeJ.php
3: Re: [amsat-bb] re:pocketsat problem
4: Re: [amsat-bb] Airline Carryon
5: [amsat-bb] T-Storms in FN66 (re: W0EEC QRV in FN66)
6: Re: [amsat-bb] Have Distortion Problems-Can't Work FO-29
7: [amsat-bb] Thank You
8: RE: [amsat-bb] Looking for a mast mount amp
9: Re: [amsat-bb] Airline Carryon
10: [amsat-bb] Caution re Online Pass Predictions on AMSAT Web Site
11: [amsat-bb] Pocketsat and logger?????
12: [amsat-bb] 'S' Band antenna/downconverter
13: [amsat-bb] 70 cms pre-amps
14: Re: [amsat-bb] www.amsat.org/amsat-new/echo/ModeJ.php
15: Re: [amsat-bb] www.amsat.org/amsat-new/echo/ModeJ.php
16: Re: [amsat-bb] Airline Carryon
17: Re: [amsat-bb] Airline Carryon
18: Re: [amsat-bb] Airline Carryon
19: Re: [amsat-bb] Have Distortion Problems-Can't Work FO-29

----------------------------------------------------------------------

Message: 1
Date: Wed, 06 Jul 2005 07:13:57 +0000
From: Nigel KC8NHF/G8IFF <nigel@ngunn.net>
Subject: Re: [amsat-bb] Airline Carryon

What no-GPS rule?
I've always been told by cabin staff that it's OK to use GPS.

Greg D. wrote:

> Hi Pat,
>
>
>
> On the other hand, about 6 years ago (before the current no-GPS rules
> went into effect),
>


- --
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
Nigel A. Gunn. 59 Beadlemead, Milton Keynes, MK6 4HF, England.
Tel +44 (0)1908 604004
e-mail nigel@ngunn.net or  nigel@ngunn.demon.co.uk
www    http://www.ngunn.net  or  http://www.ngunn.demon.co.uk
Amateur radio stations  G8IFF, KC8NHF
Member of  AMSAT-UK #182, ARRL, GQRP Club, QRPARCI, SOC #548  RAYNET
Flying Pig #385, Dayton ARA #2128, AMSAT-NA  LM-1691,
<><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><><>
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org

------------------------------

Message: 2
Date: Tue, 05 Jul 2005 20:29:05 -0600
From: <n6ors@verizon.net>
Subject: [amsat-bb] www.amsat.org/amsat-new/echo/ModeJ.php

>Besides Domenico's reply, you might check out:
>
>www.amsat.org/amsat-new/echo/ModeJ.php
>
>GL
>Mike
>K9QHO


That page, in particular lacks accuracy. Dont ask where those numbers
come from...
Desense is a very common problem in mode V/U, Lots has been written about it.
The problembmanifests itself in distortion or blocking of the receive signal.

A 100w transmitter's output measured on a spectrum analyzer typically
has almost all the signal located on the frequency of interest, the
rest of the energy is in harmonics and noise around the center frequency
(caused by noise in the pll or LO's). Requirements for spectral purity call for
80 to 85db down on the harmonics and trash.

So if the tx signal is 100w (+50dbm) and the rest of the signals are
80db down that means that -30dbm is the most that is getting to the
reciever. Depending on the receiver this may be just fine but in some
cases, I.E. satellite receivers, they are very sensitive, capable of
receiving the noise floor which may be less then -110 db.

The receivers front end filters attenuate out of band signals quite a bit
but you might need a diplexer or duplexer if it does not do it completely.
A diplexer usually consists of a high pass and a low pass filter together in
one box. They are rated by their power handling, insertion loss and
isolation. Depending on the quality of the front end of your receiver you
may only need a diplexer to attenuate the signal sufficiently (the extra 80 db
attenuation we need) to hear the satellite well. Some preamps have tuned
filters in the front end and between the preamp and the receiver may do the
job.

Going by our figures earlier if the tx signal is -30db and we are capable of
hearing the noise floor at -110db then our diplexer and our receiver front
end isolation should equal at least 80db. In this case a cheap diplexer would
suffice. Remember a diplexer also has insertion loss,  which means if it is
the first thing in your system you are raising your noise figure and decreasing
your MDS (minimum discernable signal).

If ya got all that then you can see also see that turning your power down ,
,seperating your antennas and making sure your coax dont leak helps a lot.
I hope this helps out.


Keith N6ORS
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org


Read previous mail | Read next mail


 17.11.2026 03:48:04lGo back Go up