OpenBCM V1.13 (Linux)

Packet Radio Mailbox

DB0FHN

[JN59NK Nuernberg]

 Login: GUEST





  
CX2SA  > SATDIG   05.07.05 08:30l 142 Lines 5600 Bytes #999 (0) @ WW
BID : 6571_CX2SA
Read: GUEST
Subj: AMSAT-BB-digest V2004 #779 3/3
Path: DB0FHN<DB0MRW<DB0WUE<DK0WUE<7M3TJZ<TU5EX<CX2SA
Sent: 050705/0722Z @:CX2SA.LAV.URY.SA #:6571 [Minas] FBB7.00e $:6571_CX2SA
From: CX2SA@CX2SA.LAV.URY.SA
To  : SATDIG@WW


Message: 7
Date: Mon, 4 Jul 2005 21:46:19 -0400
From: "Hal Pressman" <halpress@cinci.rr.com>
Subject: [amsat-bb] Have Distortion Problems-Can't Work FO-29

The following message was sent a couple of days ago but since I have not as
yet seen it appear on any digests since then I am reposting it.
- -----------------------------------------------------------------------------
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
--------------------------------------

Hello Fellow Amsaters,
I need your help.
I can hear ok on FO-29 but when I try to make a contact no one responds. I
think the reason is my uplink signal is seriously distorted based on
recordings I have made with a freestanding receiver. This ONLY occurs in SSB
mode. On the FM satellites, i.e.AO-51, everything is OK. I am using a Yaesu
817 for my transceiver with a 2 M amp  However the distortion occurs with or
without the amp. My antenna is a Qhtenna which consists of 2 turnstile
antennas (2M and 70CM)  made of PVC and mounted end to end on the ground
about 25 ft from my shack. I am also using an AR2 70CM preamp and a
diplexler mounted at the base of my antennas. I also use SAT PC-32 but the
problem occurs whether or not I use the software. I would love to make my
first contact on FO-29. Can anyone help me do it?

Thanks in advance for your help.

Hal
KD8SY
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org

------------------------------

Message: 8
Date: Mon, 4 Jul 2005 23:02:08 -0500
From: "Aruni" <ve4wmk@mts.net>
Subject: [amsat-bb] AO-51 sounding great again

Thank you so much Mike and the command team for your quick efforts to get
Echo back up and running again. Signals were strong tonight at 02:58 UTC
pass. Worked the following stations with my portable setup. Thanks for the
contacts.

W0EEC - FN56, FN66
VE7WFG
W7YED

Heard K5MAN, N2OEQ, KD5MSS, W4TME and AI7W, but did not want to interrupt
these stations as they were trying to make contacts with Emily, W0EEC at her
new grid.

Also hope to have a mode V/S session again on Echo!

73,

Aruni Perera, VE4WMK - EN19

AMSAT member: #35560
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org

------------------------------

Message: 9
Date: Mon, 4 Jul 2005 22:33:37 -0700
From: "kc6uqh" <kc6uqh@cox.net>
Subject: Re: [amsat-bb] Have Distortion Problems-Can't Work FO-29

Hal,
I use a vertical 5/8 wave on 2M and it works just fine on low angle passes.
You need to look at the output meter, and when talking in a normal voice see
about 1/3 or less than the full power output you see on a loud whisle into
the mike. If you adjust your mike gain accordingly you should not be
distorted.
Other causes could be RF on the coax, or an RF sensitive power supply. You
might want to try a battery on one pass and see if it makes a difference.
Good Luck,
Art KC6UQH
- ----- Original Message -----
From: "Hal Pressman" <halpress@cinci.rr.com>
To: <amsat-bb@AMSAT.Org>
Sent: Monday, July 04, 2005 6:46 PM
Subject: [amsat-bb] Have Distortion Problems-Can't Work FO-29


> The following message was sent a couple of days ago but since I have not
> as yet seen it appear on any digests since then I am reposting it.
> -----------------------------------------------------------------------------
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
--------------------------------------
>
> Hello Fellow Amsaters,
> I need your help.
> I can hear ok on FO-29 but when I try to make a contact no one responds. I
> think the reason is my uplink signal is seriously distorted based on
> recordings I have made with a freestanding receiver. This ONLY occurs in
> SSB
> mode. On the FM satellites, i.e.AO-51, everything is OK. I am using a
> Yaesu
> 817 for my transceiver with a 2 M amp  However the distortion occurs with
> or
> without the amp. My antenna is a Qhtenna which consists of 2 turnstile
> antennas (2M and 70CM)  made of PVC and mounted end to end on the ground
> about 25 ft from my shack. I am also using an AR2 70CM preamp and a
> diplexler mounted at the base of my antennas. I also use SAT PC-32 but the
> problem occurs whether or not I use the software. I would love to make my
> first contact on FO-29. Can anyone help me do it?
>
> Thanks in advance for your help.
>
> Hal
> KD8SY ----
> Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
> Not an AMSAT member? Join now to support the amateur satellite program!
> To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org
- ----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the author.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb" to Majordomo@amsat.org

------------------------------

End of AMSAT-BB-digest V2004 #779
*********************************


----
Sent via amsat-bb@amsat.org. Opinions expressed are those of the authors.
Not an AMSAT member? Join now to support the amateur satellite program!
To unsubscribe, send "unsubscribe amsat-bb-digest" to Majordomo@amsat.org


Read previous mail | Read next mail


 17.11.2026 01:57:45lGo back Go up